Using the original IRF520 power MOS tube, the output can be adjusted by PWM. Allows Arduino to drive loads up to 24V, such as LED light belt, DC motor, miniature water pump, solenoid valve After PWM adjustment, LED stepless dimming and motor stepless speed regulation can be realized. Screw terminals are provided to interface with your load an external power source. When the SIG line is HIGH, a little LED lights up, and the GND is ‘connected’ to the V-. 5pcs IRF520 MOS FET Driver Module for arduino New IRF520 driver module... 🥇Stepless dimming of LED and stepless speed regulation of motor can be realized by PWM adjustment. 🥈size: 33mm×24 mm (1.3in x 0.94in). 💎IRF520 MOSFET driver module for IRF520 power supply MOS transistors for PWM regulation output. ⚡Voltage: 3.3V, 5V. 🥉Arduino can drive loads up to 24V, such as LED light belt, DC motor, miniature water pump, solenoid valve. The V+ and Vin are continuously connected. Jual Mosfet IRF520 MOSFET Driver 100V 10A Motor Selenoid Module Arduino Optical Sensor 5PCS IR Infrared Obstacle Avoidance Sensor Module For Smart Car Robot&io Infrared Obstacle Sensor Arduino Output load voltage: 0-24V. Platform: Arduino, single chip microcomputer, ARM, raspberry pie. 💎【product parameters】Size: 33*24mm.Voltage: 3.3V, 5V.Port: digital level. How to use PWM Adjustment MOS Drive Board? The simplest way of explaining how this little board works is as below: You connect the power for the device you want to control the Vin and GND. You can power this device from your Arduino, VCC goes to the 5V connection and GND to the GND pin on your Arduino. Specifications: Operating Voltage 3.3 ~ 5V Ports Digital Level Output load voltage(V) 0 to 24 Dimensions 3 x 2 x 1cms Weight 5 grams Package Includes: 1 x IRF520 MOSFET Driver Module for Arduino Raspberry Pi